Gravitational Gold Concentrator
It is suitable for the recovery of single gold in placer gold, vein gold mines and polymetallic mines, instead of mercury plate operations. The addition of large single gold particles in the collected ore before flotation can further increase the recovery rate of gold mines, and it can also be used from gold-bearing mines. Separate single gold from flotation gold-copper concentrate and flotation gold concentrate.The device has the following characteristics:
1.Wide application field: the device can regenate various types of activated carbonon by adjusting the angle and rotational speed of furnace pipe.
2.Regeneration activated carbon in the oven retention time 40 minutes, which is applicable to the regeneration levelofall kinds of grain particles, for coal activated carbon also has good regeneration effect.
3.High degree of automation:the device operation achieves automatic control,with man-machine interface+Intelligent instrument control,reduces the operating workers and the labor intensity is low.
4.High recovery rate of Iodine value:basically returned to a new carbon levels above 90%.
5.Low carbon loss:≤1-2%(Coal carbon)But slightly higher than the JHR-O series activated carbon fuel diesel reclamation equipment
6.Easy installation, covers an area slightly larger, but the small space height requirements, large installed power.
Long service life:The core components furnace tube using thick wall (10 mm thick) 1200 ℃ high temperature resistance, corrosion resistant special stainless steel pipe.
Gravitational Gold Concentrator,Gold Extraction,Gold Recovery Equipment,Gold Washing Equipment Changchun Gold Research Institute Co.LTD , https://www.changchungoldresearch.com
Basic method for fault diagnosis of sprinklers
The basic method for fault diagnosis of sprinklers:
1. Keep in mind the time, the phenomenon, and the situation at the time of the failure of the sprinkler, the reason for the failure of the sprinkler, and whether it has been overhauled or disassembled.
2. Initially identify the fault scope and location of the sprinkler.
3, call out sprinkler fault code, and detect sprinkler fault content.
4, according to the sprinkler fault code display fault range, for maintenance, with particular attention sprinkler joints are loose, off, wire connection is correct.
5. After the sprinkler vehicle is overhauled, it should be verified whether the sprinkler fault has been eliminated.
6. If the sprinkler fault code is not adjusted, or if the content of the sprinkler fault is not found after the sprinkler is found, the fault scope of the sprinkler is roughly determined according to the fault phenomenon of the sprinkler, and the method of checking the working performance of the sprinkler components is adopted to eliminate the fault range. .