Vacuum filling construction program: When vacuum grouting, you need to follow the following process procedure. (l) After the tensioning of the prestressed steel beam is completed, remove the exposed steel strand (note that the exposed amount of the strand should be 30-50mm, not less than 3Omm), and flush the hole with clean water, and the high-pressure wind blows cleanly. (2) Seal the anchor. There are two ways to seal the anchor: 1 Seal the anchor with the sealing tool cover, clean the surface of the anchor plate before installation to ensure smoothness, and evenly coat the bottom of the grouting protection cover and the surface of the rubber sealing ring with a layer of glass glue and install a rubber seal. Circle, align the protective cover with the mounting hole on the anchor plate, tighten with bolts, and pay attention to the exhaust port; 2 Use non-shrinkage cement mortar to seal the anchor: must anchor plate and clip, exposed strand All packages. (3) Determine the vacuum end and the grouting end, install the outlet pipe, ball valve and joint, and connect the vacuum pump unit and grouting machine. (4) Weigh the raw materials according to the designed cement slurry ratio, stir the cement slurry, and measure the consistency of the slurry on-site. When the specified index is reached, the cement slurry is filtered and stored in the storage tank, and it is in agitated state before entering the tunnel. Storage tank air filter vacuum pump pressure gauge Figure 2 Vacuum irrigation equipment Construction equipment connected to the slurry storage tank after the slurry to achieve no less than the amount of pulp required to inject a 1.3 times the amount of grouting, shut down and vacuum pump Connect all valves (close valve 2, valve 4 in Fig. 2), start the vacuum pump to make the vacuum reach a 0.08 MPa and keep it stable at no less than 605. (If it is not stable, it means that there is no tight seal) Plastic Railway Sleeper,Synitheric Sleeper,Railway Glass Fiber Sleepers,Plastic Railway Sleepers Anyang Railway Equipment CO.,Ltd , https://www.ayrailwayat.com
Vacuum grouting heating process
Vacuum grouting heating process
Core Tip: [Tags: SY_Introduction]