After we have purchased 12 tons of cranes , the next task is how to operate the cranes. At the same time, the maintenance of the cranes is also indispensable. As long as the owners care about maintaining and maintaining the cranes, they will greatly reduce the failure of the cranes. It also increases its life rate, but at present, due to the economic downturn, people who often operate the crane are after all, in a small number, do not understand how to maintain and maintain the 12-ton crane, especially when the crane running time is more blind, As a result, the work of the crane cannot be carried out smoothly, which has affected the progress of the entire project. To this problem, Xiao Bian proposes the following points based on the needs of the majority of vehicle owners, hoping to help everyone. Let's talk about how to use and maintain the 12-ton crane during the run-in period! 1. Because the 12-ton crane is used very little in our lives, it is classified as a special vehicle. Therefore, after we have a crane, we must perform the operation of the crane before the work and the related machine structure. And maintenance knowledge must be a detailed understanding, because a lot of manufacturers provide services in this area, in particular to remind the majority of owners, be sure to carefully read the crane manual before the operation of the crane operation to standardize the operation. 2. After understanding the basic operation of the crane, we must avoid the workload of the crane during the break-in period. Under normal circumstances, the work of the crane cannot exceed 60% of the normal workload. It is therefore suggested that we should arrange the crane work properly. Time, early prevention of machine damage and overheating caused by long working hours. 3. We must pay special attention to the clear instructions of the cranes' instruments. If any abnormalities occur, the cranes should be turned off in time and stop working. Look for professional maintenance personnel to check the faults and causes of the cranes. 4. We must always keep the parts of the crane machine clean. If any abnormalities are found, we must promptly adjust and loosen each component so as to avoid losing the parts during operation and failing to operate normally. 5. After the run-in period of the crane work is over, we should promptly conduct a professional maintenance measure on the crane's machinery, timely carry out relevant inspections, and adjust unreasonable parts and timely replace oil and other related matters. The final summary: The use and maintenance of the 12-ton crane can be summarized as follows: understand the operating instructions, reduce working hours, timely inspection and repair, and timely replacement of oil lubrication. As long as the owners can pay attention to the timely maintenance and maintenance of the vehicle, I believe the 12-ton crane will be a good helper in your life. In this serie, it contains all kinds of our sealing gaskets. From material, we have PVC material, and also we have EPDM rubber material. From the types, we have H type, J type etc. From the colors, we have gray one, black one and white one. From the sizes, we have so many sizes which can suit for your different door thickness. For detailed information, you can search this serie or directly ask us in any time. Truck Door Seal,PVC Seals,Extruded Rubber Seal Gasket,EPDM Door Sealing Jiaxing Ganland Auto Parts Co., Ltd. , https://www.ganlandparts.com