EPS Sandwich Panel Production Line

   Components and Functions

Standard Decoilers	For use with 1200±5 mm wide steel coil sheet up to 5 tons in weight. The coil holder is supplied with two supporting wood and expanding mandrels. It is un-powered. The Max. outer diameter is 1260mm,the inner diameter is 500mm or 600mm.
Hydraulic Station	To supply the power for cutting, it is off work when the cutting stop
Consecutive Laminating Body	Consists of guiding, laminating, glue providing, glue scraping, heating, auto cutting and controlling. Â
Coil Guiding equipment	When the coil sheet come the laminator, the guiding system ensures the sheet to the correct position.
Pre-heating system	Before glue scraping, the coil sheet will be heated in this system.
Guiding roller core	When the EPS fed to the machine, the guiding roller will guide the EPS to the laminating cabinet, the roller core will go the cabinet too. This makes the EPS closer to the top and lower coil sheet, thus make the finished panel more solid.
Glue Providing	There are 4 drum stand, with proportion at 60:40 ( the glue is provided by the buyer, and the quality shall be meet the speed at 3-4 meters per minute). The glue will scraping at 4 directions,  this guarantees the glue can be supplied at different speed. This part is operated separately.
Glue Filling Pad	The pad is in to-and-fro movement, there are air cushions on the concrete pad.
Heater	To open the heating pipe or not and how many pipes to open, is depend on the temperature and the solidify time of glue. The heater is to heat the top and lower coil sheet at appropriate temperature in laminating
Cutting system ( for laminating use )	In production, when the sandwich panel meet the set length, the system will cut the panel with milling cutter. (also  equipped with another set of straight cutter)
PLC Control System	Main components imported from Mitsubishi. All language in English.
Supporting Table	The finished panel will come out to the table.
Safety Guard	All the chains and sprockets are covered with a guard. this will prevent the workers from injured
C-shaped groove-making equipment	This equipment is prepared for making the mineral wool sandwich panel
Groove-making equipment for EPS	To make the grooves of the EPS, make it possible for the buyer to produce the rabbet joint sandwich panel.
Edge cutting equipment	To amend the edge of the EPS after the panels are laminated.

Working Flow

feed the lower coil sheet   ---- sheet guiding  ----- glue adding ----- feed the top coil sheet ------ sheet guiding ----- folding ----- g;lue adding-----feed EPS panel ------- add glue to EPS panel ----- upper and lower roller of the laminator tighten and roll ------- heating  -------  groove making------post cutting  (under control of  PLC, adopt encoder to meet the set length, automatic cutting) -------- sandwich panel come to the supporting table

Create broad space, fulfill wonderful splendor

Compared with the usual machine room, Small Machine Room Passenger Elevator adopts the reasonable civil engineering layout, the machine room covers the equal area as that of the well. It saves the machine room space, and reduces the outline influence from the machine room towards the constriction. It can adapt to the buildings which has special requirements towards the outline appearance. It not only cuts down the construction cost, but also be very helpful to excite the inspiration of the construction designers to create the artistic buildings one after another.

Small Machine Room Passenger Elevator

Small Machine Room Passenger Elevator, passenger elevator cost, passenger elevator size

Shandong Bester Elevator Co., Ltd. , https://www.besterlift.com