Most of the installation methods used in the hydraulic winch in the wrecker are center-mounted, and now the hydraulic winch on the side is also gradually used in some wreckers. Under normal circumstances the winch wrecker are installed in two or one, but also need to be decided in accordance with the relevant vehicle design needs. The wire ropes on the vehicle winch can use the two directions of the lower rope and the upper rope. In order to prevent the rope from being broken, the vehicle winch should be equipped with a pressure rope. The selection and use of steel wire ropes and winches are all critical for wreckers. They are all related to the safety performance and technology of driving a vehicle. Therefore, the following matters should be taken into account during installation and use: 1. Before a winch is installed on a wrecker, it is necessary to carefully inspect all parts to see if any components are damaged. If there are damaged parts, they must be replaced before they can be installed. 2. The connection brackets, connecting seats and winch connections should all be mechanically stabilized with high-strength Bolts at the level of 10.9 or higher, so as to further ensure the strength of the connection. 3. After the winch is installed, it is necessary to check whether the hydraulic line is connected or not, and whether the clutch can be properly separated and combined. The operation of the winch drum is not normal and no jamming may occur. 4. When wringing the wire rope around the wrecker of a wrecker , it is necessary to hit the wire head into the rope empty of the roll, then tighten it with the set screw, and it is out of the condition that the wire rope is under the condition of collecting the rope. After four or five turns, the wire rope is tightly wound with a force of 3-5 kN. 5. Wreckers need to ensure that the maximum declination does not exceed three degrees when rewinding and retracting the reel, so as not to prevent the winch from deflecting and unscrewing. When it is deactivated, the wire rope should be pressed tightly with a pressure rope to prevent the wire rope from being tangled due to the back feed. 6. After the wrecker of the wrecker has been installed, it is necessary to carry out no-load operation when it is re-used for a long period of time and when the heavy-duty test is performed. This facilitates the smooth running of the motor. 7. When lifting heavy objects and pulling, it is not possible to disengage the clutch of the winch. When the wrecker of the wrecker is in operation, the wire rope needs to be kept on the drum for five laps. Precision,Non-standard Parts,Non-standard,part Non-Standard Parts,Slide Retainer,Slide Die Holder,Precision Slide Retainer Changsha Borun Mould Co. Ltd. , http://www.borunmouldparts.com
